How to unhide a component?

[steed66]

test.png (42.22 KiB) Viewed 954 times

I would like to remove the masking under PROTEUS 8 where the arrow is so that when the circuit is manufactured, the area is only tinned to allow better dissipation of the transistor on "top" and "bottom copper".

[David]

Hi,

If you mean you would like to remove the resist from the copper zone in the centre of T1 then you can either Select the OPen Solder Resist on the Edit Zone form, or draw the resist on the resist layer using the 2D graphic icons.

Regards,
Dave.

[steed66]

What I want is that there is no protective varnish in this place so that the contact of the transistor on the copper is done more efficiently.

[steed66]

Here is what I have at my disposal in "EDIT ZONE"

[David]

Hi,

Please can you email me your customer number to support@labcenter.com and a link to this post so that I can validate you on the forum and provide further assistance, thanks.

Regards,
Dave.

[steed66]

Hello, sorry for not having answered you earlier but I found and solved my problem.
Thank you again for your help.