The active relay model works well during simulation,but the relay's appearence can't go back to state 0 when simulation is stopped.
What's wrong with it?
Problem of self-build active model.
Problem of self-build active model.
- Attachments
-
- RLY_A.rar
- Acive Relay,RL1 is hierarchy module,RL2 is a reference component.
- (6.6 KiB) Downloaded 67 times
Enclosed there's one that works. When you make the device you don't need the property STATE=0 and it's the reason of problem indeed. There were also other small problems, so I have put on the same design all the Symbols. You can decompose your component and compare with mine.
When you do make use of RTVPROBE, remember that a load resistance value can also be specified into, so the resistor accross C1 & C2 is useless. You can simulate the coil resistance by including its value directly in the property 'Load Resistance' of RTVPROBE or pass a parameter.
When you do make use of RTVPROBE, remember that a load resistance value can also be specified into, so the resistor accross C1 & C2 is useless. You can simulate the coil resistance by including its value directly in the property 'Load Resistance' of RTVPROBE or pass a parameter.
- Attachments
-
- RLY_A_1.zip
- (7.36 KiB) Downloaded 82 times
Kind regards,
Ettore Arena - Labcenter Electronics.
Ettore Arena - Labcenter Electronics.
The model is OK,now I need to study Laplace Primitives.
Thanks a lot!
Would you like to give me an example of using Laplace Primitives? I need to introduce them to our customers.
Would you like to give me an example of using Laplace Primitives? I need to introduce them to our customers.
Attached here is a couple of elliptical filters - even and odd degree - which I have synthetized with Laplace primitives.
- Attachments
-
- EllipticFilter_Even_Odd.zip
- (127.4 KiB) Downloaded 103 times
Kind regards,
Ettore Arena - Labcenter Electronics.
Ettore Arena - Labcenter Electronics.
Wonderful!
Thanks again for your help!