Hi
I am trying to create a simulation of a lookup table for demonstration.
I have created a multilevel file which has active inputs/outputs (logicstate, logictoggle & logicprobe) on both the root page and the child page. When I try to simulate only the child page seems to simulate.
I created a single level schematic & it simulates fine.
I created a multilevel design with all inputs brought to the top level through terminals. It simulates fine.
I would like to hide some of the detail in the lower circuit and still have it simulate properly.
Any ideas ?
Problem simulating multilevel design
Problem simulating multilevel design
FJF
CarlowIT
CarlowIT
Bug - simulating hierarchical designs
Hi Ettore,
My apologies for the delay in replying. I was away last week.
I turns out that there is a bug in the system when animating of hierarchical designs. See the message below which I received from David Spencer.
Regards,
FJF
>Hi,
>Having looked at the design and spoken to a colleague, there is >apparently a bug with the animation of hierarchical designs and logics.
>If you hit play on the lower sheet you will see that the simulation works >as you stated. If you stop the simulation, go to the parent sheet and hit >play, toggle a probe and enter the child sheet you will now find that the >animation does not work. What is happening is that the design is still >working however it is the visual changing of the circuit. If you were to >add a voltage probe you would see the changes.
>This is a bug which is on the list to fix.
>Kind regards,
>David Spencer - Labcenter Electronics
My apologies for the delay in replying. I was away last week.
I turns out that there is a bug in the system when animating of hierarchical designs. See the message below which I received from David Spencer.
Regards,
FJF
>Hi,
>Having looked at the design and spoken to a colleague, there is >apparently a bug with the animation of hierarchical designs and logics.
>If you hit play on the lower sheet you will see that the simulation works >as you stated. If you stop the simulation, go to the parent sheet and hit >play, toggle a probe and enter the child sheet you will now find that the >animation does not work. What is happening is that the design is still >working however it is the visual changing of the circuit. If you were to >add a voltage probe you would see the changes.
>This is a bug which is on the list to fix.
>Kind regards,
>David Spencer - Labcenter Electronics
FJF
CarlowIT
CarlowIT