If for any reason this forum moves again, would it be to much to be informed before you next log in. Considering that Email addresses need to be used to obtain access it would be great if the forum could inform users of changes via Email.
GREAT NEW LOOK
I have a question while I'm here. I've been using MPLAB and ISIS for close to two years now (great idea intergrating the two), and for the asolute life of me I can't figure out how to change the properties of the PWM SERVO. I use servos all the time in projects designed in ISIS, but I'd like to be able to change the input signals to the servo I.E Neutual = 1.7 milliseconds - 45 degress = 2.3 milliseconds and 90 degress = 1.2 millisceonds.
Any ideas or help on this.
Regards,
David
Moved in VSM section as this has to do with simulation.
EA
Please note
You need to set servo motor properties such that:
Minimum Angle = +90°
Maximum Angle = +45°
Minimum Control Pulse = 1.2m
Maximum Control Pulse = 2.3m
Have a look at attached sketch. The pulse generator was set with:
Initial (Low) Voltage = 0
Pulsed (High) voltage = 5
Start = 0
Rise Time = 1n
Fall Time = 1n
Pulse Width (%) = 12 (for 1.2ms) or 23 (for 2.3ms)
Frequency (Hz) = 100
The circuitry in the dashed box is not that functional for the simulation itself, although it's useful to measure the pulse with usec resolution.
Minimum Angle = +90°
Maximum Angle = +45°
Minimum Control Pulse = 1.2m
Maximum Control Pulse = 2.3m
Have a look at attached sketch. The pulse generator was set with:
Initial (Low) Voltage = 0
Pulsed (High) voltage = 5
Start = 0
Rise Time = 1n
Fall Time = 1n
Pulse Width (%) = 12 (for 1.2ms) or 23 (for 2.3ms)
Frequency (Hz) = 100
The circuitry in the dashed box is not that functional for the simulation itself, although it's useful to measure the pulse with usec resolution.
- Attachments
-
- Servo.JPG (98.75 KiB) Viewed 741 times
Kind regards,
Ettore Arena - Labcenter Electronics.
Ettore Arena - Labcenter Electronics.