Draw PCB lines
Draw PCB lines
How to draw curved lines on Proteus 8.16, everyone. Previously, when I used 8.15, when I wanted to draw a curved PCB, I just needed to press ctrl
Re: Draw PCB lines
Toggle curved cornering (SHIFT+C) or dynamically from the Route Command Centre (keyboard 'R').
Re: Draw PCB lines
Thank you. Let me try
Re: Draw PCB lines
I want to draw curves like this. In previous versions, I just needed to press Ctrl
- Attachments
-
- IMG_20231109_203821.jpg (153.46 KiB) Viewed 927 times
Re: Draw PCB lines
Hi,
As Iain mentioned - SHIFT+P to turn off PnS and then SHIFT+C Toggles Curved routing on / off (prior to 8.17 where just SHIFT+C is required). Please see the Route Command Center help in the ARES Help file. Alternatively: https://www.youtube.com/watch?v=bKgomx9Q9uM.
If you require any further support please email your customer number to support@labcenter.com, thank you.
Regards,
Dave.
As Iain mentioned - SHIFT+P to turn off PnS and then SHIFT+C Toggles Curved routing on / off (prior to 8.17 where just SHIFT+C is required). Please see the Route Command Center help in the ARES Help file. Alternatively: https://www.youtube.com/watch?v=bKgomx9Q9uM.
If you require any further support please email your customer number to support@labcenter.com, thank you.
Regards,
Dave.