While running a PIC-16 firmware built from scratch, I have correct behaviour until I use HX711 A channel, but shifting to B channel with due changes ( 26 clock pulses instead of 25 and obvious swapping of A with B input lines) I have no meaningful output. It's not due to the different value of amplification between the channels(32 instead of 128). It's also evident visualizing PD_SCK and DOUT on the virtual scope.
Kind regards
possible bug in HX711 model
Re: possible bug in HX711 model
Hi,
Please can you email your project and code and link to this topic to support@labcenter.com, so that I can investigate your issue? Thanks.
Regards,
Dave.
Please can you email your project and code and link to this topic to support@labcenter.com, so that I can investigate your issue? Thanks.
Regards,
Dave.
Re: possible bug in HX711 model
Thank you, Dave.
I sent the mail you requested.
Kind regards
Alberto
I sent the mail you requested.
Kind regards
Alberto
Re: possible bug in HX711 model
Hi Alvin,
We have found and fixed a bug in the HX711 model, however you will not receive the fix as you are not entitled to the latest release through using a cracked version of the software
Regards,
Dave.
We have found and fixed a bug in the HX711 model, however you will not receive the fix as you are not entitled to the latest release through using a cracked version of the software
Regards,
Dave.
Re: possible bug in HX711 model
HX711 has now been fixed in the Proteus 8.15 Beta 2 (Build 33861) for wrong behaviors when switched to channel B.
Kind regards,
Ettore Arena - Labcenter Electronics.
Ettore Arena - Labcenter Electronics.