Renamed pins want not to be renamed

[sycomore]

Hello from France,

I'm not an ace with proteus...

On my future PCB, i will have a lot of terminalblocks.
On the schématic, i want to have pins with A,B,C,D, etc, not 1,2 1,2 1,2 (i use only 2 pins TB)

I start from TBLOCK-M2 in the library. I decompose/edit properties
Pin name A, Defaut pin number 1
Pin name B, Defaut pin number 2
Make device
Now the pin's name is ?

I do the same but
Pin name 1, defaut pin number A
Pin name 2, defaut pin name B
Make device
Now the pin's name is always 1 and 2

Where i do a misstep ?

Thank you in advance
philippe

[David]

Hi,

When you rename the pin names they will become unbinded from the associated package - which gives you the '?' on the Pin. When you remake the schematic part you will need to reassign the correct pins to the correct pads in the Packaging Tool section of the Make Device form:

1.png (28.12 KiB) Viewed 1225 times

Kind regards,
Dave.

[sycomore]

Thank you but may be am i dum, impossible to arrive to me target...

I will solve my problem by creating 13 tblocks for 26 letters
J1 for A,B J2 for C,D etc
Now its how i want but each letter is put just in the circle in the end of the pin (inside the tblock) and they is the same size, black on brown, my old eyes don't appreciate

FORUM1.jpg (50.02 KiB) Viewed 1224 times

Thanks

[David]

Hi,

Is this not what you are after? (Note I only did an 18 pin variant not 26!).

2.png (8.58 KiB) Viewed 1222 times

If you need further assistance please email your customer number to support@labcenter.com, or alternatively see the Help Tutorial 'Creating New Devices'.

Kind regards,
Dave.

[sycomore]

I have tried, i have tried and again and again and miracle, all its ok now !
The letters don't want moving, its nothing, i will take care

Thank you