Hello,
I need to create a big hole in the middle of my pcb (rectangle 3cm x 5cm).
How can I do that ? Can I create another board edge in the middle ?
Thanks for reply,
Goupil
PCB Big hole in the middle
Re: PCB Big hole in the middle
Hi,
Either:
1. Create a rectangle on MECH1 and when generating the Gerber files make sure you select MECH 1 as the routing Slotting layer.
2. Add another Board edge - Note that this can confuse Zones if they are being used as Zone require a main Board edge.
If you require any further support please send in your customer number to support@labcenter.com Thanks.
Regards,
Dave.
Either:
1. Create a rectangle on MECH1 and when generating the Gerber files make sure you select MECH 1 as the routing Slotting layer.
2. Add another Board edge - Note that this can confuse Zones if they are being used as Zone require a main Board edge.
If you require any further support please send in your customer number to support@labcenter.com Thanks.
Regards,
Dave.