So, I downloaded the Demo version 8 to test.
i just did a simple circuit to light a LED. My surprise is that the program do not calculated the right current for my particular LED.
I chose a red LED from the part list.
Put +5V ----> Resistor ----> LED ----> GND.
LED: RED 2.2V@350mA.
Resistor: (5-2.2)/0.35 = 8 ohms.
So, the ammeter should measure 350mA, but it is showing only 255mA.
Why is this happening?
Look:
http://img.photobucket.com/albums/v222/ ... _error.png
http://img.photobucket.com/albums/v222/ ... _error.png
Thanks
Error on LED current measuring.
Re: Error on LED current measuring.
I made a test on version 7.9 and the error persist.
Maybe is a problem with the LEd model. Maybe this one can not simulate high power leds.
bye
Maybe is a problem with the LEd model. Maybe this one can not simulate high power leds.
bye