Labcenter Community Support Forums

Here is the file. See the included video.

Edit: File attachment is giving HTTP error. File size is 1.6 MB and .rar format.

Couldn't attach the video file which shows Gmin Stepping error. I am getting HTTP error while attaching the mp4 video file in .rar format.

Here are the files. It simulates without Gmin stepping error with and without chassis only if LD to Gate resistor is added, else with chassis it gives the Gmin Stepping error... Please fix it Ettore as I have to do a Pump Soft Starter project. I cannot use Chassis because if I use Chassis then in Os...

Adding a Chassis gives fatal Simulation error... Gmin stepping...

The same circuit simulates well without Chassis if MOC3021 is replaced with MOC30XX model. The Lamp then turns On.

I am using Proteus 8.16 SP1 version.

Why this Triac circuit doesn't work?

I need a TRIAC-LED simulation model. You can make just one V and Color flexible model.

Provide DC Motor Equation.

I am making a DC Motor .dll based model and require its equation for RPM.

I set VNOM, RCOIL, LCOIL, LOAD, MASS and I want equation for RPM and I.

How to use 2x Nanos?

I am VSM for Arduino.

I want to know how to use 2x Arduino Nanos in the same project file with 2x source code tabs one for each Nano.

Ettore wrote:Please look at your PM. I have sent a generic part & model for the PH sensor.

At Ettore, please send me the pH sensor model in private message.

I would like my power rail be from the power supply I designed. Basically VDD not be from default configuration. How do I do this? Yves By default the power line has GND = 0V VCC/VDD = 5V VEE = -5V If you have a say PIC18F model then change its Hidden pins connections to say VDD1 and VSS1. In power...

Provide a simulation circuit to measure mains AC 300Vrms AC using HCNR200. The output of HCNR200 should be within 5V DC after additional circuit if required so that it can be directly interfaced with MCU ADC input. MCU is a 5V type.

Can we use the BMP180 model to simulate BMP280?

If yes, what settings should we do to the model properties?

Only 90 and multiple of 90 are allowed in ISIS schematic. In ARES component placement, you can do more. I don't have ARES or PCB Layout. I need to do a NeoPixel simulation with Arduino UNO and for that, I want to place the NeoPixel strips like wheel spokes. So, I want to rotate the components as ne...

It's is not working for me. I tried both methods. When some arbitrary value like 22.5 is entered in the transformation toolbox and a component is tried to place on the schematic then immediately even before the component is placed the transformation toolbox value changes back to 90 degree. Please sh...

How to rotate any components to any desired angle like 5 degrees or 5.48 degrees or any arbitrary value?

Why I am not getting chopped negative half-wave?