Labcenter Community Support Forums

I need to reopen this topic.

I am trying to simulate the example project GPS Module with LCD, but I have an error when I write address in the virtual gps window. Attached hardcopoy.
What do I need to do?

Dear Ettore:

The project is too big for attach in this forum.

I sent you by email.

Thanks for you reply

Sorry, previous hardcopy image showed cut.

Attached the correct one:

I have a project for PIC16F1937 based in PICDEM2 EVALUATION BOARD EXAMPLES. I am using XC-8 compiler version XC8 v2.30. When I build the project, I can see this message at the end of the proccess: Failed to set firmware property. The project compiled ok and the simulation work properly. What does th...

We want to change the size of the pads in a package. For example, we start from the DIL16 package that uses 50x30th DILC type pads. We want to change the DILCC pads for the C-60-30 pads and save the package as DIL16B. To do this, we have to select pad C-60-30 and click on each of the pads to change ...

The font size used by i2c debugger is too small in my case because I am using a display resolution of 3840x2160 (4k screen).

Is it possible configure it?

I am practicing with a multi boards project. My design has got two boards. The first one with two sheets and the second one with one sheet. Imagen_7635.jpg Imagen_7637.jpg I select from the design menu the option Go to sheet for each one of them. In sheet 1 of board 1 and open the dialog window prop...

I try to simulate a 4528. The Q output chanel run properly, but NOT Q is always float state (green square).

Is there any issue about it?

Thanks

If I have got two or more vias in the same track, when I want change the type of one via and I use the contextual menu option 'change via style' Proteus change all the vias in this track.

Is there any parameter to select change all vias in the tack or only this via?

User Proteus version 8.7.sp3. I don't know the version of Arduino compiler. I ask him that He used command -V, but I can't see the number version on the log list. You can see that -V option is in the first line. The complete log output is below: **************************** mksketch -C pro328 -T -st...

When I compile this project everything works correctly, but when the client tries to compile it he receives the error that is shown in attached image.

Can you give me any clue as to what the problem is and what should we configure differently?

I'm using seven segmented display in my panel of IoT. When I try to compile, I have got an error in the code that is automated writed by Proteus. I can't solve this problem because proteus rewrite these sentences with only one parameter when compiler wait for two. What is wrong? I send you my projec...

Dear Dave:

I sent it to you by email.

Thanks.

Dear Andrew:

Tested and all running ok.

Thanks.

I upload a image with equivalents arduino uno and arduino mega connections schema with NodeMCU ESP8266 for if it is usefull for another reader.